BDS Lockset Wrap - 38mm Door - 60mm Backset - Satin Stainless Steel
The BDS 11351140 is a stainless steel lockset wrap plate designed to suit entrance style knobs and levers with a 60mm backset on 38mm thick doors.
It is commonly specified to reinforce damaged door faces or to add strength around entrance lock installations where the existing cutout has been enlarged or damaged.
Key Features
- Lockset wrap plate for entrance style knobs and levers.
- Designed for 38mm thick doors with a 60mm backset.
- Reinforces damaged or weakened door faces around the lockset cutout.
- 55mm hole diameter to suit standard entrance lockset spindles.
- Manufactured from stainless steel, finished in satin stainless steel.
Suitable Uses
- Repairing doors with enlarged or damaged lockset cutouts.
- Strengthening entrance doors fitted with 60mm backset entrance knob or lever sets.
- Retrofit installations on commercial and residential doors where the door face requires reinforcement around a 60mm backset lockset.
Full Specifications
BDS Lockset Wrap Plates - Item Code Family
Frequently Asked Questions
- What locksets does this wrap suit?
The 11351140 suits entrance style knobs and levers with a 60mm backset on 38mm thick doors. Unlike the BRAVA 6000/8000 series specific wraps, this plate is designed for general entrance locksets and is not restricted to a specific lockset brand or series. - Can this wrap be used on a door thicker or thinner than 38mm?
No. This wrap is sized for 38mm thick doors only. For 35mm or 40mm thick doors with BRAVA 6000/8000 series locksets, refer to the Item Code Family table for the correct variant. - Does this include the lockset?
No. This is the wrap plate only. The lockset is purchased separately. - Can this be used on a new door installation or is it only for repairs?
While most commonly specified for repair or reinforcement of damaged door faces, it can also be used on new installations where additional face reinforcement is required around the lockset cutout. - Is correct alignment critical during installation?
Yes. The wrap must be centred accurately over the spindle hole and aligned with the latch cutout. Misalignment will result in poor lever and latch operation and may cause premature wear.
Additional Information
- Commonly specified during refurbishment or repair of entrance doors where the lockset cutout has been damaged, enlarged, or requires reinforcement.
- This wrap suits general entrance style knobs and levers with a 60mm backset. It is not a BRAVA 6000/8000 series specific wrap - for those locksets on 35mm or 40mm doors, refer to the Item Code Family table.
- The 55mm spindle hole suits standard entrance lockset spindles. Confirm the spindle diameter of the intended lockset before ordering.
- Correct alignment is critical - the plate must be centred over the spindle hole and aligned with the latch cutout before fixing.
- When ordering for a complete door, two wrap plates are typically required - one for each face. Confirm quantity before ordering.
